This article mainly introduces Removal and Installation Komatsu WH716-1 of ENGINE HOOD
Removal
1 -Lift the engine hood (1).
2 -While supporting the engine hood, loosen and remove
the screws (2) retaining the hinges (3).
3 -Remove the cotter pin (4), the backing washer, and disconnect the gas damper (5) from its support (6).
RKTA0350
4 -Lower the hood and place an anti-slip block (A) between
lower edge of hood and body; then, strap the hood and
connect it a hoist.
5 -Remove the hood (1).
Komatsu Forklift LinkOne EPC 11.2012 Spare Parts Catalog
Installation
• To install, reverse the removal procedure.
[*1]
1 -Adjust the position of the hood, ensuring that the lock assembly (7) is centred in relation to the retaining hook (8).
2 -Adjust the hinges vertically (3) to allow the closure sealing strip (9) to evenly rest along the length of the hood.
Komatsu LinkOne Construction Parts Catalogue 2017
3 -Adjust the hinges (3) horizontally until full contact between the sealing strip (10) and the engine-transmission
mount (11) is achieved.
