This article introduces doosan DL350-5 Loader Clutch -KV and KR Disassembly
2023.07 Doosan DMS-5 Data Monitoring System Diagnostic Software
- Squeeze rectangular ring out(Arrow).
NOTE: The following figures show the disassembly of
Clutch -KV.The disassembly of Clutch -KR is similar.
- Pull taperedrollerbearing from the shaft.
- Removeopposite taperedroller bearing accordingly. (S)Grab sleeve -5873001057
(S)Grab sleeve -5873001059
(S)Basic set-5873001000
4.4.Squeeze retaining ring out.
Separate plate carrier from the shaft.
(S) ThreeOleg puller-5870970003
Doosan Diagnostic Tool UVIM Support Doosan Excavators High Quality
6.
Squeeze retaining ring out and remove plate pack.
7.
Preload compression spring, squeeze retaining ring out and remove components.
(S) Assembly aid -5870345088
8.Lift piston using compressed air out of the cylinder bore and remove it.
- Remove both O-rings (Arrows).
HA9M2045
Figure 151
- Lift idler gear a bit using pry bars (Figure 153).
11. Apply puller and separate idler gear from the clutch shaft
(Figure 154).
12.Squeeze retaining ring out and remove ball bearing.
The disassembly of Clutch -KR has to be carried out accordingly.
NOTE: The disassembly of Clutch -KR has to be carried out accordingly.
Doosan Machine Engine Diagnostic Software Package 2024 One PC Installation
