This article describes Caterpillar 311F LRR JFT crawler excavator oil cooler removal
A . Remove the alternator and the mounting bracket. For correct steps, see Disassembly and Assembly, “Alterator Gator-Disassembly”.
pay attention to
Keep all the parts clean without impurities.
Impurities can cause rapid wear and shorten component life.
pay attention to
When inspecting, maintaining, testing, adjusting and repairing products, be careful to ensure that the liquid is held in the container. Before opening any chamber or disassembling any part with stored storage.
Dispose of all liquids in accordance with local regulations and
instructions.
1. Remove coolant into a suitable container from the cooling system. Refer to the Operation and Maintenance Manual, “Cooling System Coolant-Replace” for the correct steps.
2. If the engine oil is contaminated with the coolant, the engine oil and filter must be replaced. Regarding the correct steps,
Refer to the Operation and Maintenance Manual, ” Engine Oil and Filter-Replacement.
Caterpillar 18 Digits Factory Password Calculator One-Time Calculate Service
3. Disconnect the coolant hose from the tube assembly (5).
4. Remove the bolts (6) from the pipe assembly (5). Remove the tube assembly (5) from the engine oil cooler assembly (3).
5. Remove the O-ring seal (7) (not shown) from the tube assembly (5).
6. Remove the bolts (8) and bracket (9) from the engine oil cooler assembly.
7. Remove the booster chamber cover (4). For the correct steps, see Disassembly and assembly, “Turbocharger-disassembly”.
8. Remove the bolts (1) from the engine oil cooler. Do not remove the bolts in the (X) position. Cool down the engine oil
While the device assembly is removed from the cylinder block.
Note: The length of each bolt varies. Record the position of the bolts of the different lengths.
9. Remove the gasket (2) (not shown).
CAT Caterpillar ET 3 Diagnostic Adapter 317-7485/478-0235 Diagnostic Tool-high quality
1 0. If necessary, follow steps 1 0.a to 1 0c to remove the engine oil cooler.
a. Remove the bolts (13) and (14) from the engine oil cooler assembly (3).
b. Remove the cooler base (12) from the housing (10).
c. Remove the gasket (11).
