Bobcat 741_742_742B_743_743B_743DS STEERING LEVERS
Removal and Installation guide
2022 Bobcat Service Analyzer Diagnostic Software 90.00
NOTE: Early production machines used 3-piece assembly.
Current production machines use 1-piece shield which
must be removed as a unit.
Remove the front panel
Remove the bolts and remove both side shields 00.
Remove the bolts from the steering lever shield (g & [Q].
Remove the steering linkage at the steering levers
Disconnect the auxiliary linkage from the right steering lever
lID
Remove the bolts (Item 1) from the pivot bearings ‘Cl.
Installation: Tighten the bolts to 25-28 ft.-Ibs. (34-38 Nm)
torque.
2022 Bobcat Service Analyzer Diagnostic Software 90.00
Remove the steering lever assembly @.
Repairing the Steering Levers
Remove the rubber bushing and the Teflon bushing from the
steering levers.
Install the new rubber bushings into the steering levers using
two sockets and a vise ~l
2022 Bobcat Service Analyzer Diagnostic Software 90.00
Install the Teflon bushings on the steering levers [!!).
Install the two steering lever assemblies together ~.
Check the pivot bearings and replace as needed.
