This article mainly introduces This article mainly introduces Removaland Installation of the Isuzu Engine 4HJ1 N-Series Engine Mount
Isuzu E-IDSS Diagnostic Service System 06.2022
Removal:
1. Disconnect the battery cable negative terminal.
2. Drain the engine coolant.
3. Remove the cab.(Non-tit cab model only)
Refer to “FRAME AND CAB”Section 2.
4. Remove the fan shroud.
· Remove reservoir tank hose and fan shroud.
5.Remove the fan belt.
·Remove adjust plate lock bolt.
·Loosen generator fixing bolt then remove fan belt.
6.Remove the support rubber.
.Remove two fixing nuts at the crossmember side.
Isuzu G-IDSS Diagnostic Service System 03.2022 Download and Installation
·Separate the generator from the engine.
·Remove the support rubber nut from engine foot side.
·Remove the support rubber while raising the engine.
Installation:
1. Install the support rubber.
· Install the support rubber while raising the engine.
· Tighten the fixing nuts to the specified torque.
Tightening torque Engine foot side:82 N.m(8.4kg-m/61 Ib-ft)
Crossmember side:48 N-m(4.9 kg-m/35 lb-ft)
2. Install the AC generator drive belt.
Refer to “Drive Belt”in Section 6B, Engine Cooling.
3. Install the fan shroud.
· Install the fan shroud and clip the reservoir tank hose.
4. Install the cab.(Non-tilt cab model only)
Refer to “FRAME AND CAB”Section 2.
5. Refill the engine coolant.
6. Connect the battery cable negative terminal.
ISUZU IDSS Diagnostic Adapter System Support G-IDSS/US-IDSS/E-IDSS
